Appliance Repair Wyomissing Pennsylvania

VIA INC Rated out of 5 stars based on 0 customer reviews

We serviced a
WHIRLPOOL ICE MAKER
Model KUID308HPS00
Near Wyomissing, PA 19610
Justin L.
Job Details: 07/21/2022
Cx complaint after last repair on 7/18/22 the unit hasnt made since. Was ablle to access unit and found it running with the water going over evap tray. Found compressor to turn on and run about 20 seconds then shut off. Used amp clamp and found when compressor starts its pulling 15Amps then goes to 5.6-5.7 Amps before shutting down again and suction line gets cold. Ohmed compressor to find from top to bottom right 4.4 Ohms top to bottom left 10.2 Ohms and 14.4 Ohms from left to right .Contacted techline and spoke to Drew SR#7734131525 signs pointing to a restriction in the system. Contacted SS tech MM and ordering the parts he requested and a 5 call count sealed system repair office will need to set return; ordrng 1 2217446 (condensor base) and 1 WPW10605286 (compressor) and 1 W10528572 (tube) and 1 WPW10534030 (gas valve) and 1 WPW10206473 (coil solenoid) and 1 WP2313624 (condensor) and 1 WPW10200037 (drier tube) and 1 WPW10218037 (evaporator)
We serviced a
WHIRLPOOL ICE MAKER
Model KUID308HPS00
Near Wyomissing, PA 19610
Marc M.
Job Details: 07/18/2022
"cx complaint unit not producing ice. cx stated that the unit made ice for about a week after previous SS repair, even thru a holiday weekend where they used more ice than usual. cx stated after that point the unit started producing a 'grinding' sound and resulted in feeling warmer in the compartment and eventually stopping ice production altogether. upon arrival checked cycle and found unit performs flush cycle with no issue. upon the flush cycle ending found that the compressor would not start. found failed start device. replaced with van stock and tested. unit now checks good. documented with techline; used 1 WP2217224 (start device) from stock"
We serviced a
WHIRLPOOL DISHWASHER
Model MDB9959SKZ0
Near Wyomissing, PA 19610
Marc M.
Job Details: 07/18/2022
"cx complaint unit leaking from what appears to tbe the front left corner of the unit. inspected unit and removed front outter panel of door. checked latch, dispenser, and vent fan assembly for any active leaks or water trailing/residue. found no leaks. checked leveling feet and door adjustment for deviation within initial install. foudn installign to appear correct and within spec. checked the 90degree elbow at the drain hose to make sure there are no kinks or tears that would induce a leak during drain cycles. while inspecting unit only noticed where there was a dent at the left rear corner of the unit which could be the cause of a leak at the tub seam. contacted techline to review and doc. all findings and techline advised replacement of the tub assembly. sr7734129830; ordrng 1 W11409866 (tub assembly (ship to cx))"
We serviced a
WHIRLPOOL REFRIGERATOR
Model WRS571CIHZ01
Near Wyomissing, PA 19610
Fred G.
Job Details: 07/11/2022
"cx complaint units ice been keeps freezing up into one big ice cube. they can see unit is leaking from ice maker. inspected unit and entered into diag and found when running test 44 and found unit to harvest ice, ran test 45 and found when unit was dispensing water to icemaker that the water was spraying out and hitting front of ice maker. i found hard water build up on dispensing hose. was able to clear it out and unit now checks good. charged cx only for service call $120. advised cx to get a water softener."
We serviced a
WHIRLPOOL ICE MAKER
Model KUID308HPS00
Near Wyomissing, PA 19610
Marc M.
Job Details: 06/09/2022
cx stated after previousn sealed system repair unit did not produce any ice. inspected unit upon arrival and found that the unit had leak in system. no 134a. could not isolate leak sans the dye not permitted to be used on undercounter icemakers. replaced entire sealed system in liue of identifying the point of failure. after having installed sealed system found that the unit still would not hold charge. this time is was clear that the aluminum lines at the evap were damaged in shipping and being aluminum a patch could not be soldered. unit will again need 4 count ss repair.; ordrng 1 WPW10218037 (evaporator) and 1 WPW10605286 (compressor) and 1 WPW10200037 (drier-tube) and 1 WP2313624 (condenser) and 1 WPW10206473 (coil-solnd) and 1 WPW10534030 (valve-gas) and 1 W10528572 (tube)