"cx complaint scrapping noise in agitate, found basket loose, no errors stored, when spinning basket by hand knocking noise from transmission, shaft dropping with load, scrapping cam, ordering transmission, cam,belt,spanner nut and wahsplate........2 count transmission job; ordrng 1 W11449840 (transmission) and 1 W10721967 (drive pulley) and 1 W11239857 (belt) and 1 W11551646 (spanner nut) and 1 W10752283 (washplate)"

"cx complaint scrapping noise in agitate, found basket loose, no errors stored, when spinning basket by hand knocking noise from transmission, shaft dropping with load, scrapping cam, ordering transmission, cam,belt,spanner nut and wahsplate........2 count transmission job; ordrng 1 W11449840 (transmission) and 1 W10721967 (drive pulley) and 1 W11239857 (belt) and 1 W11551646 (spanner nut) and 1 W10752283 (washplate)"

"cx complaint longer than normal cooking times and surface too hot, found no errors, found proper 118/118/237 at terminal, preheated to 350/400/450 all temps dead on, at 450 cooktop trim 160* glass around burners 130, no gaskets leaks , porper insulation around oven, called tech line they said to read TSP w11544031 which shows UL limits for surfuces all were within spec, cx very disappointed in product will mostl likely return unit, working as designed per tech line"

"cx complaint longer than normal cooking times and surface too hot, found no errors, found proper 118/118/237 at terminal, preheated to 350/400/450 all temps dead on, at 450 cooktop trim 160* glass around burners 130, no gaskets leaks , porper insulation around oven, called tech line they said to read TSP w11544031 which shows UL limits for surfuces all were within spec, cx very disappointed in product will mostl likely return unit, working as designed per tech line"

"cx complaint cent burner flames excessively high, found LP orifices reversed allow max gas to simmer, swapped orifices and flame returned to normal, tested all ops ok.....explained lp conversion and how BTU drop for each burner and flame adjustement is normal per tech line"