Appliance Repair Willards Maryland

VIA INC Rated out of 5 stars based on customer reviews

We serviced a
WHIRLPOOL WASHER
Model WFW5605MW0
Near Willards, MD 21874
Michael E.
Job Details: 07/13/2023
Vacuumed out water from unit. Cleared hair from drain filter. No punctures found in bellow gasket but still replaced due to leaking out bottom of door. Rqan quick clcle to completion and no leaks. Unit is now working properly. Job is complete
We serviced a
WHIRLPOOL WASHER
Model WFW5605MW0
Near Willards, MD 21874
Michael E.
Job Details: 06/30/2023
"F9E1 error code. Drain is barely pumping water out. Unit leaked in the front again. Also door not unlocking. Door not unlocking may be caused by unit not draining. Marking bellow gasket and drain pump for return visit. Ordering door latch just in case. On repair visit Check drain filter first. Also, previously did not find problem in bellow gasket but leaking in front center suggests that bellow gasket may be leaking. Confirmed water is leaking from center of door and running down the front of the front panel. Called WPTL SR 7736758129 Cannot reschedule due tio 2 techs needed.; ordrng 1 W11565030 (door latch)"
We serviced a
WHIRLPOOL WASHER
Model WFW5605MW0
Near Willards, MD 21874
Michael E.
Job Details: 06/01/2023
"Replaced the rotor, stator and control as per previous diagnosis. Tested unit and it is now working properly. Note: in diag spin it did not get to 820 RPMs but it did in drain and spin cycle. Unit is now working properly. Job is complete"
We serviced a
WHIRLPOOL WASHER
Model NFW5800HW3
Near Willards, MD 21874
Michael E.
Job Details: 04/18/2023
CX complaint: error code. Tested and verified complaint. F9E1 error code. In diagnostic unit shut off after fill. Drain is very slow. Unit is stacked. Marking control and drain pump for return visit. Cannot reschecdule due to 2 tech needed.; saved tckt
We serviced a
WHIRLPOOL REFRIGERATOR
Model WRV986FDEM01
Near Willards, MD 21874
Michael E.
Job Details: 02/13/2023
Replaced the LED control as per previous diagnosis. Tested unit and it is now working properly. Job is complete