"upon arrival pressures at -20 L, and 75 H pressurized 140 psi nitrogen, sprayed all joints with soap bubbles, no leaks visible, backed pressure of to 120 psi, after 20 min, psi dropped to 117 psi called techline spoke with tj, unit sent for review. advised cx whirlpool would contact me or them with resolution.; saved tckt"

"cx complaint no cool, checked temps, both rc and fc at 60 degrees, removed evap cover, spoke with AR advised AR unit has partial frost pattern, was advised to order compressor and evap, spoke with office, scheduled return visit 4/18/23 3 count; ordering 1 W10507884 (compressor) and 1 WP2188823 (evaporator)"

"replaced control, heater did not come on, after 15 min run time still no frost pattern, replaced compressor drier and evap, pressurized, no visible leaks, vacuumed and charged, low pressure at 0, frost pattern forming, unit working as designed."

"replaced control, heater did not come on, after 15 min run time still no frost pattern, replaced compressor drier and evap, pressurized, no visible leaks, vacuumed and charged, low pressure at 0, frost pattern forming, unit working as designed."

"upon arrival both compartments room temp, evap compartment hot, heater energized, all thermistors reading 3.2-3.4k ohms, reset unit compressor runs for 2 min then shuts down cooling, and energizes defrost heater, called techline spoke with rit sr7735804311, advised to replace relay board, called parts ordering, cost breakdown control W11449482 $112.87 thermistor not needed, $-64.88 labor $110.00, collected $157.99, scheduled for 2-28-28; ordrng 1 W11449482 (control)"