Appliance Repair Sinking Spring Pennsylvania

VIA INC Rated out of 5 stars based on 0 customer reviews

We serviced a
WHIRLPOOL DRYER
Model WED8000BW0
Near Sinking Spring, PA 19608
Justin L.
Job Details: 07/19/2022
cx complaint on sensing cycle unit shuts off right away. Was able to access unit and when I entered diag i found codesf4e3 restricted air flow f4e4 L2 line voltage error f4e1 heater relay or connector problem. Verified unit to heat and have proper airflow. Tested moisture strips in diag and no response. Verified continuity in the harness and found that the moisture sensor is reading OL. Ordering sensor and once in office will need to contact cx and set return; ordrng 1 W10171086 (moisture harness)
We serviced a
WHIRLPOOL DISHWASHER
Model MDB4949SHB
Near Sinking Spring, PA 19608
Marc M.
Job Details: 07/18/2022
cx complaint unit not draininig tub at end of cycle. inspected unit and found that the drain cycle does activate when selected. drain pump runs and no items are blocking the pump from rotating the impellor. found no standing water in tub upon arrival so began 'normal' cycle and drained prematurely to test drain. found drain pump would then intermitently not rotate. removed panel to check again and found that the the harness feeding the pump was loose and not consistently sending voltage to the pump. fully inserted harness and tested unit. unit now checks good.
We serviced a
WHIRLPOOL REFRIGERATOR
Model GD5DHAXVY06
Near Sinking Spring, PA 19608
Justin L.
Job Details: 07/14/2022
"Cx complaint unit not cooling. Was able to access unit and found failed start device. Removed and checked resistance at the the compressor and found 3.5 Ohms, 3.5 Ohms, 6.5 Ohms. Checked outlet and found 122.6 VAC. Verified harness is sending voltage to compressor and harness had continuity. Replaced start device with one from van stock and when plugged unit in start device flashed and started burning. Unplugged unit and spoke to Sealed system techs MM and EW. Ordering necessary parts for repair and setting 3 called count sealed system. Once approved office will need to contact cx to set return; ordrng 1 WPW10189190 (start device) and 1 WPW10662129 (run capacitor) and 1 WPW10143759 (filter drier) and 1 W10233961 (compressor), used 1 WPW10189190 (start device) from stock"
We serviced a
MAYTAG DISHWASHER
Model MDB9959SKZ0
Near Sinking Spring, PA 19608
Fred G.
Job Details: 07/13/2022
"cx compaint unit is displaying a f9e1 error code. inspected unit and entered it into diag and found error codes f9e1, f8e4. cleared error codes and ran a auto test and the unit was having trouble draining. pulled unit out to find the drain hose was connected to another black rubber hose that led to the sink. i also found the hose was kinked and that the unit had a double loop. meaning the extra hose had a loop and the factory hose had a loop.sk;l i found the factory hose could reach sink drain without the extra hose. i removed the hose and ran the factory drain hose to the drain under sink. ran auto test again and found the unit now drains so much better. unit now checks good."
We serviced a
WHIRLPOOL REFRIGERATOR
Model WRB322DMBB03
Near Sinking Spring, PA 19608
Justin L.
Job Details: 07/07/2022
No answer at the door so reached out to office and they contacted cx to find out the address is wrong. Will need to reschedule as of now no further work needed