Appliance Repair Pequea Pennsylvania

VIA INC Rated out of 5 stars based on customer reviews

We serviced a
WHIRLPOOL REFRIGERATOR
Model WRF555SDFZ15
Near Pequea, PA 17565
Justin L.
Job Details: 10/16/2023
Cx complaint door doesnt close by itself and if they force the left door the right door pops open. Was able to access unit and verify concern. Found cx is slamming door which is forcing air in and then the door forces open. I lowered the front feet to with door closure and am able to get door to open and close no issue but cx is unhappy so contacted techline and spoke to Butch. No parts to replace as unit is operating as designed no further work needed
We serviced a
MAYTAG REFRIGERATOR
Model MSS25C4MGK01
Near Pequea, PA 17565
Justin L.
Job Details: 07/17/2023
CX complaint unit not making ice. Was able to access unit and found icemaker getting voltage but not going through rotaion. Replaced with pre-id and icemaker rotated attempted to fill but frozen fill tube. Steamed and tested unit is now operating as designed no further work needed; ordrng 1 look (look)
We serviced a
WHIRLPOOL WASHER
Model WTW5057LW0
Near Pequea, PA 17565
Justin L.
Job Details: 07/13/2023
"Cx complaint unit not going through cycle. Was able to access unit and verified concern. Ran unit and found when it starts to spin it shuts down. Found F7E1 error. Ohmed out shifter and found OL. Replaced with van stock and tested unit now operates as designed no further work needed; ordrng 1 W11481722 (actuator (JL VS)), used 1 W11481722 (actuator (JL VS)) from stock"
We serviced a
MAYTAG WASHER
Model MVW4505MW0
Near Pequea, PA 17565
Justin L.
Job Details: 06/30/2023
Was able to access unit and replace part. Tested unit and unit now checks good no further work needed
We serviced a
MAYTAG WASHER
Model MVW4505MW0
Near Pequea, PA 17565
Justin L.
Job Details: 06/22/2023
Cx complaint unit not starting cycles. Was able ot access unit and found failed lid lock. Found control sending voltage but latch just clicks but never locks. Ordering part and once in office will need to set return; ordrng 1 W11513248 (lid lock)