As per previous tech was able to access unit and replace parts. Heated gasket and unit now operates as designed no further work needed

Was able to access unit and replace control. Calibrated and tested unit now operates as designed no further work needed

"CX complains unit is not making ice. CX states another company has done work on unit within last month. Found unit to not have water in icemaker, no ice in ice bin. FC shows 16*F. Found unit condenser to be completly blocked, was able to remove restriction and restore air flow. Retested temp in FC to ensure temps are dropping, unit dropped to 14.6*F in RC after about 10 mins. Found unit evap harness to be building up frost around defrost thermistor without reading it. Ordering evap harness for use on return, also found right side RC gasket to have failed and will need replaced. Ordering gasket for use on return.; ordrng 1 W11378944 (gasket (blk)) and 1 W11334745 (EVAP Harness)"

Cx complaint unit not draining and lid locked. Was able to access unit which was partially dissasembled and found Unit has 122.6VAC incoming into board but no led. Lid lock from J4-1 to J4-3 74 Ohms J4-1 to J4-2 74 ohms and J4-2 to J4-3 is 0.0 with the lid locked. Ohmed out drain pump and found 19.9 Ohms at pump itself and same through the harness. Ohmed out motor at J3-1 to J3-2 and found 8.5 Ohms. J3-1 to J3-3 8.5 OhmsContacted techline reported findings and unit will need control only. Quoted cx for repair and collected for service only as cx wants to decide and will call back in

Was able to access unit and replace icemaker. Watched as it harvested and filled unit now checks good no further work needed