washer stacked unit noise and error code displayed when in use entered diag f8 e1 error stored in fault history tested cold water barely coming in to unit when callig for it slight noise in the process will need second person to remove dryer to access valves; ordrng 1 W11316255 (cold valve) and 1 W11316256 (hot valve)

"CX complant. Still smell gas and sparks when igniting different burners. Inspected unit and found no gas leak either at burner heads , Valves , regulator or supply line using a infinicon gas leak detector. Checked each burner for proper ignition and all burners ignte properly , and igniter shuts off after switched to high or other setting other than ignite. Told CXburners will continue to try and ignite if gas on any burner is on for saftey reasons. Job completed, RB"

"CX complant. Washr dosent wring clothes out all the time, Inspected unit and found F0E2 and F5E2 error codes for over sudz and lock failure . when going into diagbostics console did not want to respond when using steam , cycle, 12 buttons , Ran unit and machine filled and agitated fine, Ran drain and spin and unit drained after Advised CX to cut back a little bit on load sizes. Further work needed. RB; ordrng 1 W11565030 (lock) and 1 W11325569 (console)"

at times error displayed found errors for acu comm with console and stuck button errors and at times no sound replaced console with new console stuck on model for oven unabe to enter diag to change reinstalled old console and ordering new one with control; ordrng 1 w11460596 (console) and 1 W11325784 (control)

range right front and left front burners slow to igniting at first found debris in right front and both are sparking and getting gas ordering burner heads and caps; ordrng 2 W10891987 (burner head)s and 1 W11121392 (burner caps)