Complaint was that unit had a burning smell and the lint wasn't getting pushed out confirmed issue seen the the blower wheel pulley was not on the blower wheel confirmed issue reinstall the wheel and belt tighten the pulley and tested unit everything works as it should

"Replaced LED board, unit is now working properly."

Installed new LED Modules and tested. Unit is still not turning on. The LEd is not gettign voltage. I called techline and they told me to test the LED Control Board. I tested P3 1 -2. 0 voltage. Unit has a bad control module. Collected in full. Ordering LED control module.; ordrng 1 W10804160 (cntrl-elec 146.21)

"opened system and seemed nice and full of 134a. rpelaced the compressor coupler drier then vacumed system down and filled to recomended and started cooling. unit is good to go; ordrng 1 w10913906 (coupler SD V/S) and 1 w10143759 (uv drier SD V/S), used 1 w10913906 (coupler SD V/S), and 1 w10143759 (uv drier SDV/S) from stock"

"cx complaint not cooling, found compressir, humming loud then overheating, ordering compressor, 2 count sealed system, called office scheduled for 10/19 after 9 am if possible, collected $139 cx paid in full, parts and labor CBE; ordrng 1 WPW10507886 (compressor CBE) and 1 W10843121 (drier CBE)"