"installed new control, ran diag cycle. ran normally until drain. drain pump pulsing 3 times then staying off. vent fan ran afterwards, error flashing f8-e4 called techline, spoke w/ nate reorder drain pump, slightly out of specs, - 81-95 ohms, and control,; ordrng 1 W10866116 (cntrl-elec) and 1 WPW10531320 (drain pump)"

"cust stated unit leaking from inside door on left side. took off outer door panel, noticed gasket to vent assy not positioned properly. ran diag cycle, no leaks, replaced vent assy"

"the pully failed and was stripped repleced pully now check sok; ordrng 1 W10721967 (drive pulley) and 1 drvs (drvs), used 1 W10721967 (CAM) from stock"

"unit storing error f7-e5, shifter fault. found harness failed at shifter, ordering lower harness. ; ordrng 1 W11448788 (harness, lower)"

"inconsistant heating. tested unit on arrival, heating and tumbling normally, vents clear, good air flow. added wet clothes, continued tumbling, stopped heating. found wire harness not seated on motor, losing connection when vibrating. removed and reinstalled harness, verifed secure and unit heating."