Appliance Repair Great Mills Maryland

VIA INC Rated out of 5 stars based on 0 customer reviews

We serviced a
WHIRLPOOL REFRIGERATOR
Model WRT318FMDW09
Near Great Mills, MD 20634
Shane B.
Job Details: 10/21/2022
cx complaint is when the IM cycles it leaks water from behind unit. confirmed complaint. i found the valve has a pin hole near the top and when IM cycles water sprays from it. replaced valve with preIDed part and tested IM again. IM filled with no leaks. unit is working as designed.
We serviced a
WHIRLPOOL RANGE
Model WFG320M0BS3
Near Great Mills, MD 20634
Robert A.
Job Details: 10/19/2022
"Cx complaint that the unit is not reaching temp but flashing a 'F3' error code. I inspected the unit and confirmed the complaint. I preheated the unit to 350 degrees, about 2 min later the 'F3' code flashed and it constantly beeped. I checked the ohms reading for the sensor and it was good (1.22K ohms). I replaced the sensor because the connector was a little more loose than normal. I preheated again, same thing. I checked the harness to the control and found the wire being pinched against the frame. I repaired the wire and tested the unit twice for the cx. It preheated to 350 degrees, then 400 degrees as well. The unit is now working as designed."
We serviced a
AMANA WASHER
Model NTW4516FW3
Near Great Mills, MD 20634
David J.
Job Details: 10/12/2022
Cx complaint unit does not agitate or spin. Inspected unit and found issue. Unplugged unit and removed old capacitor and replaced with new. Cleared any errors and ran a test cycle. Unit completed and had no errors. Re calibrated unit and now is working as it should. JOB COMPLETE
We serviced a
AMANA WASHER
Model NTW4516FW3
Near Great Mills, MD 20634
David J.
Job Details: 10/12/2022
Cx complaint unit does not agitate or spin. Inspected unit and found issue. Unplugged unit and removed old capacitor and replaced with new. Cleared any errors and ran a test cycle. Unit completed and had no errors. Re calibrated unit and now is working as it should. JOB COMPLETE
We serviced a
AMANA WASHER
Model NTW4516FW3
Near Great Mills, MD 20634
David J.
Job Details: 10/12/2022
Cx complaint unit does not agitate or spin. Inspected unit and found issue. Unplugged unit and removed old capacitor and replaced with new. Cleared any errors and ran a test cycle. Unit completed and had no errors. Re calibrated unit and now is working as it should. JOB COMPLETE