Per previous diag I was able to access and replace the ice maker. i then tested the ice maker and found that it is able to harvest and fill. Job complete

Cx complaint is that the burners are shutting off when going from high to low and the oven does not seem to be getting as hot as it should. Upon arrival I found that the burners have started functioning correctly. I attempted several times to recreate the issue and was unsuccessful. i then attempted to do an oven calibration and found the control board is not allowing me to enter the oven temp offset to adjust it. I am ordering the control board. Please contact cx when the parts are available to schedule the return visit. Cx will video the burner issue if it occurs again.; ordrng 1 W11620559 (Control)

Per previous tech I was able to access and replace the mullion. The doors are now sealing as intended. Job complete

"Cx complaint is that the ice maker is not producing ice consistantly, Upon arrvial I found that the ice maker was shut off. I turned it on and jumped it into a harvest cycle. It was able to harvest but is loud and jerky in its motions. I am ordering the ice maker. Please contact cx when the parts are avialable to schedule the return visit.; ordrng 1 W11546935 (Ice maker)"

arrived tried per TL again with the start device and compressor and found this time they work. i replaced compressor and start device and pulled 29 in vac for about 20 o mins filled to 64g r600 and allow time to cool. also returning the evap that wasnt used before. fyi