Appliance Repair East York Pennsylvania

VIA INC Rated out of 5 stars based on 0 customer reviews

We serviced a
WHIRLPOOL REFRIGERATOR
Model MFF2258VEB4
Near East York, PA 17402
Sal R.
Job Details: 07/21/2022
I was able to access and replace both parts. Unit test good. CX was paid in full on last visit.
We serviced a
KITCHENAID REFRIGERATOR
Model KFXS25RYMS4
Near East York, PA 17402
Sal R.
Job Details: 07/15/2022
"Per the previouse tech, I was able to access and replace the icemaker. I found that the IM called for water and completed a harvest when jumped. Unit test good. CX paid in full on last visit."
We serviced a
WHIRLPOOL REFRIGERATOR
Model MFF2258VEB4
Near East York, PA 17402
Sal R.
Job Details: 07/14/2022
"CX complai nt is that the unit is freezing things in the RC and that the icemaker is leaking. I found that the damper motor door is not closing all the way allowing air to come into the RC all the time. I also found that the icemaker is leaking. I am ordering 1 damper motor (WPW10196393) and 1 icemaker (D7824706Q). I have set a return date for 7/21, I collected $498.24 for service , parts, shipping, taxes, and labor charges. CX is paid in full.; ordrng 1 D7824706Q (icemaker 38 @ tribs)"
We serviced a
KITCHENAID REFRIGERATOR
Model KFXS25RYMS4
Near East York, PA 17402
Marc M.
Job Details: 07/12/2022
cx complaint unit not producing ice. inspected and found that the ice maker generates a loud clickign when cycling. checked further and found the fill tube to be clear and not frozen over or collapsed. checked valve and found that during the icemaker cycle it is never call ign for 120v to the dual valve. unit does dispense water at the dispenser. determined the failure to be the icemaker itself which will come accompanied by a revised icemaker harness as well. collected for full oow repair.; ordrng 1 W10882923 (icemaker)
We serviced a
WHIRLPOOL FREEZER
Model WRF757SDHZ03
Near East York, PA 17402
Marc M.
Job Details: 07/12/2022
cx complaint FC door handle still loose. was able to completely remove door handle and tighten the mounting screws to the door skin with an impact drill. following correcting the mounting screws was able to also tighten the door handle hex set screws and test vigorously for any tolerance. cx also requested the rc doors be leveled and was able to perform adjustment via the right bottom hinge set screw. unit now checks good.