Replaced inlet valve per prior diagnosis. CX has both wall valves leaking when turned off. Tested unit after repair and the WM is now working properly. Went over deep fill options with CX. Job is complete

CX complaint: unit wont start. Tested and verified complaint. Unit was in a drain cycle. Allowed unit to complete drain. F9E1 error code. Unit has no hot water supply and was set on cold so i adjusted to tap cold. Drain line only goes down from back of unit so it starts losing water as soon as filled. I advised CX to reroute drain and explained water temp settings. Unit is working properly. Job is complete

Replaced inlet valve per prior diagnois. Pleaced inlet hose screen before valve in case it clogged so not to destroy valve. Hooked water line up and turned unit on. Unit starting to allow water into inlet jet for about 1 minute then the valve starte making a loud whining noise. Turned off water and removed water line from DW. Pulled screen and it was completely clogged with the same slimy substance that the valve is clogged with. Suggested CX contact someone to inspect his well. and per CX request did not hook water line back to valve and kept water supply to it off. Unit is working properly. CX 100% has an issue with his well and/or water supply. Job is completed. Only charging CX $75 labor which include $8 difference for part

CX complaint is DW not working. During inspection I found the inlet valve was completely caked with a brownish clear sludge. This unit has not been turned on since last techs visit. Water will not even pass through valve to go into inlet jet.. Unit needs new inlet valve. Sugested to CX to get inlet hose screens to keep sludge from clogging valve. Valve in $8 less than inlet jet and will be credited toward labor at completion of job. Talked to Shamiya and one valve in OS. Scheduled CX for last stop this coming Sunday 9/17; ordrng 1 W11434044 (inlet valve)

"RC at 61 degrees. Evap has ball of ice on capilary and no frost other than that. Compressor is too hot to keep my hand on it.. Amp draw while hot 0.81/0/81/0/0. I let compressor sir for few min and plugged it back in. Per TF, ordering compressor, evap, coupler, drier, 3 count and SS tech needed; ordrng 1 W10140971 (compressor) and 1 W11507067 (evap) and 1 W11506635 (coupler) and 1 WPW10143759 (dryer)"