MOTOR AND CAP NEEDED I GOT UNIT TO RUN BUT HAD TO START WITH TURNING DRUM BY HAND THE PART IN THE BOX ISN'T THE CORRECT PART. CAP SHOULD BE WITH THE MOTOR; ordrng 1 W11209428 (motor-drve)

new idler and rollers needed making sqealing noise total-$350 $200 paid today $150 owed on return; ordrng 4 WPW10314173 (support)s and 1 W10837240 (idler pulley)

"Replaced parts per previous tech, ran normal cycle and unit would make buzzing noise and not spin. Used meter to run test 3, motor circuit and resistance was in range on connections through control. Found the capacitors were at fault. Ordering parts, once available contact cx to reschedule; ordrng 1 W11209428 (motor drive) and 1 W10724418 (capacitor)"

THE LATCH IS NO GOOD SO WHEN I GOT THE DOOR OPEN CLOSED IT BACK DOOR LATCHES AGAIN LATCH IS NLA I CALLED THE WARRANTY AND THEY SAID THEY WILL REACH OUT TO CX AND FOR US TO CLOSE TICKET

CX COMPLAINT UNIT MAKES NOISE AS IF IT'S GOING TO START THAN IT CLICKS FROM BOARD A FEW TIMES THAN STARTS BLINKING THE TIME AS IF DOOR IS OPENED; ordrng 1 W11565029 (Appliance Control Unit (acu)) and 1 W11551763 (Whirlpool Dryer Door Switch) and 1 WP8577274 (thermistor)