arrived to start replacing the compressor and dryer first amongst doing so ran nitrogen through to test for any leaks before moving to evap saw constant dropping of psi @140 purging through. amongst soap bubbles all joints near compressor dryer and condenser line foiudn no leaks detected and also none at evap but when looking with mirror and checking closely. i found the unit to have 'hissing' fainlty from inside the steel line out the cabinet to dryer where the plastic rubber ring seals line in.. removed to gain access to see. and found pin hole at the line in cabinet called TL sp[oke to John gave info and attached area of leaking area and wp will reach out to cx.

Per previous tech I was able to access and replace the igniter. I then tested the unit and found that the unit is igniting immediately. Unit is now functioning as intended. Job complete

"Cx complaint is that the unit is still Freezing products in the RC. Upon arrival I found that the RC temp is at 29 Degrees. I also found that the FC temp is 2 degrees. I accessed the evap and verified that there are no restictions in the return ducts. I also found that the frost pattern was light and only on the top 2 or 3 rungs of the evap. I tested the thermistors from both sections at the control and found the RC 6.2 K Ohms and FC 10.3 Kohms after both sections had been opened for several minutes. I also did an amp draw test at the compressor and found it to be at .62 amps. I called TL and informed them of my findings. Per TL they want a sealed system tech to come back and check operating pressures and test for leaks. I am ordering the sealed system repair evap, comp, f dryer; ordrng 1 W11580057 (Compressor) and 1 W11109499 (Filter Dryer) and 1 W11578004 (Evap) and 1 876765 (Tubing kit) and 3 w11506635 (Process stub)s"

cx complaint that unit is intermtitingly stopped making ice at times and will go day or so with out dumping anything out. i tested power to valve and icemaker checks good.. replaced icemaker and tested rotated and filled checks giood

CX complqi t is that the unit would not start a wash cycle. I found that the unit has no stord error codes and completed a recalibration and auto test with out issues. I was able to edjucated CX on 2 step start process. Unit test good.