Replaced damper from previous diagnosis and unit is now working as designed. Job is complete.

"Cx complaint is unit not cooling. Arrived at store and found unit plugged in. Unit had been plugged in for about 8hrs prior to visit. Cx advised unit had been keeping food frozen but ice cream was completely melted and food spoiling in RC. Temps on arrival (empty unit) were 52 in RC and 24 in the FC. Evap had what i consider heavy frost but only on the top two rows of the evap. Compressor was warm but not hot to the touch and condensor temps were almost identical incoming and oncoming on the condensor. Amp draw was 0.66amps. Unit appears to be low on refrigerant even though it was only plugged in for 8 hrs, the unit has indications of being low on charge. Ordering compressor, evap dye drier and coupler. Cannot reschedule at this time. 3CT SEALED STSTEM; ordrng 1 W11625643 (evap) and 1 W11656989 (compressor) and 1 W10143759 (drier (service)) and 1 W11506635 (coupler)"

"CX complaint is dryer no heat. Inspected/tested and verified. Found high limit thermi=ostat OL. Replaced TCO from VS. Shortened vent line for CX. Dryer is now heating and working properly. Job is complete; ordrng 1 W10900067 (cutoff-tml FRVS), used 1 W10900067 (TCO FRVS) from stock"

CX complaint is unit will not always start. Inspected/tested and found CX has gas dryer hooked up to same outlet as WM. This is most likely effecting the control when both are running at same time. Suggested CX have dedicated outlet ran for dryer on its own breaker. Also suggested CX correct her drainage to give more pipe for water to drain before it hits the Ptrap.Ordering control to remedy issue CX says she will have electrician run dedicated outlet before we return. Also ordering splutch and belt to correct squeaking noise under unit. Cannot reschedul due to FBO part needed(control); ordrng 1 W11627413 (control) and 1 W10721967 (splutch) and 1 W11239857 (belt)

"CX complaint is unit will not agitate. Inspected/tested and found ring on slider defective and slid down. Replaced slide from pre-id and clutch from VS. Calibrated and tested after repair and the WM is now working properly Job is complete.. Email address confirmed; ordrng 1 W10754448 (clutch FRVS), used 1 W10754448 (CLUTCH FRVS) from stock"