"Replaced compressor from previous diagnosis. Pressure tested, vacumed down and refilled with 68g of r600a. Unit is now working as designed. Job is complete."

"CX complaint is WM banging. Inspected/tested and found 2 level legs installed at bad angle and are defective. Replaced from VS. Leveled unit and in hi spin had chirping noise. Isolated that to the belt or splutch. Replaced both from VS. Calibrated and retested and WM is now working properly. Job is complete; ordrng 1 W11239857 (belt (FR VS)) and 1 W10721967 (drive pulley (FR VS)) and 2 WPW10687506 (leveling leg (FR VS))s, used 1 W10721967 (splutch(FR VS)), 1 W11239857 (belt (FR VS)), and 2 WPW10687506 (leg (FR VS)) from stock"

CX complaint is no cool in FC. Upon arrival found pressures at 25vac on LS and 40 on HS. Low side teeterin between 18 and 25 in vac. Found clog at joint on coupler and when running nitrogen through unit drier was spurting. Put nitrogen through until there was a steady flow into cap line. Replaced drier and coupler and pressure tested unit at 140psi and found no leaks. Vac'd down to 30in for 20mins and then filled with 56g of R600a. After pressures equalized low side sat at 12in vac and high side was at 50psi with compressor on. Spoke to EW. These are good pressures. Informed CX 24-36 for unit to get to temps. Job is complete

"Cx stated oven wont turn off inspected tested and verified cx complaint found bake relay welded sending constant voltage to bake element, element is NLA cx wants to just buy a new oven. Trip and diag covered by saftey Job is complete"

"Cx stated oven wont turn off inspected tested and verified cx complaint found bake relay welded sending constant voltage to bake element, element is NLA cx wants to just buy a new oven. Trip and diag covered by saftey Job is complete"