Was able to access unit and replace parts per previous visit. Tested unit and unit now works as designed. No further work needed.

Was able to access unit and replace parts per previous visit. tested unit and unit now works as designed. No further work needed. cx paid for labor with card.

"CX complains unit is getting hot but is not drying clothing. CX states this has been issue for about 4 days. Found unit to be recieving 122.5vAC to L1, 122.23vAC to L2 and 235.6vAC from L1-L2. unit does heat up at first but after about 3 mins the element goes off and unit is no longer sending voltage to element. Checked fuse, tco and element resistance, element shows 9.8 ohms, tco shows 0.0 ohms, and fuse shows 0.0 ohms. found 122.5vAC goin into thermostat but only .34vAC coming out. Found unit motor was rubbing belt causing oremature wear. Unit will need belt, motor, blower wheel, idler, (4) rollers, thermostat, for repair. Office to schedule repair with cx when parts are approved; ordrng 1 WP3387134 (thermostat) and 1 W10857612 (timer) and 1 279827 (motor) and 1 341241 (belt) and 1 WP691366 (idler) and 1 WP694089 (blower wheel) and 4 349241T (rollers)s"

"CX complains unit is not cleaning dishes and unit is not spraying out of spray arms. Cx is without warranty. Quoted cx for service fee. Cx agreed to service fee. Put unit into diagnostic test and unit showed f4e3-wash motor not running f7e1-no heat. Unit filled with water but did not circulate the water, unit is recieving 122.3vAC to sump motor but sump motor is not pumping. Unit will need sump replaced for repair. Quoted cx for sump replacement, cx does not want repair done at this time. Advised cx the quote will stand for 30 days and service fee will be covered for 30 days but after that quote may change and service fee will need to be paid again. CX does not want repair at this time, no further work needed unless cx calls in and agrees to repair. CX EMAIL CONFIRMED."

"Was able to access unit and replace parts per previous visit. Ran unit through calibration cycle, then retested unit through diagnostice cycle. Unit went through diagnostic cycle with no issues. Unit now works as designed. No further work needed."